Tayana 37 Pilothouse Cutter
(REF# 51714)
This boat has been sold
11.3m (37'0"), 1985, 1 x diesel 30hp
(Service records available)
GRP Construction, Long Keel underwater profile, 6 berths
|
| Extra Details
| Designer: | Robert Perry |
| Builder: | TAYANA |
| Fuel capacity: | 1 x 282 ltr (62.0 G) |
| Water capacity: | 2 x 568 ltr (125.0 G) |
| Holding tank capacity: | 1 x 136 ltr (30.0 G) |
| Last survey: | Unknown |
|
|
Mechanical
1 x diesel 30hp, Yanmar (1985)
fresh-water cooled,
wheel steering,
shaft drive, 3 blade bronze prop(s).
Fuel consumption (approx) 3.2ltrs/hour,
Cruising speed 6.5 knots,
Max speed 8.5 knots.
Generator output 0KVA.
-Onan Gen Set
-Inverter with trickle charger
Diesel tank is black iron with poly exterior coating. Last inspection on the inside of the tank showed it to be in good condition. Located under V Berth (about 80 gallons based on actual fill)
Main water tank is stainless steel and was replaced in mid 90's, located under cabin sole forward of the engine, about 90 gallons
Second water tank is flex rubber (new 2006) located under single quarter berth about 30 gallons
There is a 3way valve located by main water tank to select between the two water tanks.
Holding tank is under the engine and is fiberglass, molded into keel. about 30 gallons
Yanmar 3qm30f engine has about 1580 hours and is in good condition
Koboto diesel 6KW genset has about 850 hours.
|
|
Electrical Systems
12 volt, 4 batteries charged by: engine, solar panels, shore power, generator
|
|
| Dimensions
| LOA: | 11.3m (37'0") |
| LWL: | 9.5m (31'2") |
| Beam: | 3.5m (11'5") |
| Draft Min: | 0.0m (0'0") |
| Draft Max: | 1.8m (5'9") |
| Clearance: | 15.1m (49'7") |
| Displacement: | 8,163kg (18,000.0lbs) |
| Headroom: | 1.9m (6'4") |
| Storage: | In water |
|
| Construction
GRP Construction with Long Keel underwater profile, gelcoat finish.
Mono-hull with a modified Lon Keel 3/4-5/8.
Mark I hull
A couple of thru-hulls were replaced.
Ballast is sectioned off.
|
| Rig
Sloop rigged ISOMAT -France Aluminium spars (1985), with Stainless Steel standing rigging (unknown year) |
| Sails
Slab reefing mainsail (unknown year)
Furling headsail (unknown year)
4 halyard winches,
4 sheet winches
Main is Manageable
-110 Genoa-Great Shape
-90 Club foot Yankee Jib-Good Shape
-Storm sail-Great shape
|
| Accommodation
6 berths with 2 doubles and 2 singles in 1 cabin(s).
3 burner gas cooker, with Oven. Sink, Fridge, Freezer, Cabin heating, Air conditioning (1 Air conditioning Units)
1 heads (Manual), 1 handbasin, 1 shower.
Manual water system
Pressurised water system
Hot water system
Head was rebuilt 1.5 years ago. |
|
| Nav Equipment
Compass, Speed, Wind, Echo sounder, VHF, SSB, GPS, Chart plotter, Autopilot, Stereo, Clock, Navigation lights |
| Deck Gear
3 anchors (Fortress 27 Danforth, 2 Bruce(1-66 lbs, 1-33 lbs)),
27.432 metres of chain,
22.86 meters of warp,
Warps, Fenders, Boathook, Swim Ladder, Instrument Covers, electric Simpson Lawrence windlass (with remote control),
Zodiac dinghy (unknown year) (Inflatable).
15hp outboard, Mercury, Short shaft (unknown year).
-Other Anchor has same amount of Chain and Rode.
-Water maker mounted but not installed(villager 2000) never used.
-Heavy Drogue included
|
| Fishing
|
|
| Toys
|
| Safety Equipment
Gas detector, Life jackets, Life buoys, Horn, 3 bilge pumps (2 manual / 1 electric) |
| Lying
FT. MYERS |
| Broker's Comments
Register with Boatshed to see 65 extra photos of this Tayana 37 Pilothouse Cutter.
WE HAVE ANOTHER DIAMOND IN THE ROUGH!!
This is a true cruising sailing vessel, fully equipped and ready for the deep blue water with lots of clean up projects.
This is a Pilothouse version of a Tayana 37, a proven offshore passage maker. The layout is ideal for cruising with or without passengers.
Interior is in good condition. She does need some organization, but most do. The salon is large, but needs attention with her upholstery. The head (rebuilt)is forward and is very spacious and has a separate shower! Storage abounds in this boat!
There has not been a recent survey and the boat has not been sailed for about one year. This boat needs an experienced boat person to get her back into her prime condition. Most all of her rigging and fittings appear to be in good condition. The windows will need some good old fashion elbow grease and plenty of polishing. The teak is weathered and needs cleaning. All of the deck woodwork needs to be refinished. Her hardware is surely unquestionable top quality.
Do not come expecting a turn key boat! This boat needs a real Sailor to make her whole again. But man... What a boat that another lucky sailor will have!
These boat details are subject to contract.
Note: Offers on the asking price may be considered.
This Tayana 37 Pilothouse Cutter has been personally photographed and viewed by ERIK MALTBY of Boatshed Fort Myers. Click here for contact details. |
|
